Extended Hex Output Shaft for AndyMark AM001 Gearbox.
Installing this shaft (SolidWorks file below) with a hex bore sprocket allows gearbox to direct drive one wheel and chain drive additional wheels at the same time.
Additional items needed:
1 - 0.500" hex bore double sprocket, (12 tooth is typical).
2 - 0.500" hex bore bearing, 1.250" OD. One must be flanged. Both can be flanged.
1 - 0.500" snap ring.
Installing this shaft (SolidWorks file below) with a hex bore sprocket allows gearbox to direct drive one wheel and chain drive additional wheels at the same time.
Additional items needed:
1 - 0.500" hex bore double sprocket, (12 tooth is typical).
2 - 0.500" hex bore bearing, 1.250" OD. One must be flanged. Both can be flanged.
1 - 0.500" snap ring.

am-0001_output_shaft.slddrw |